Magic
Module™ Starter Kit
For Programming
ELK-MM443
and ELK-MM220 modules |
|
ELK-MK400
Includes one Magic Module (ELK-MM443)
Controller |
|
Get started by using your
personal computer and the ELK Starter
Kit which includes a Magic Module™
Controller, power supply, software
for easy programming, RS-232 to RS-485 data bus converter and
serial cables you need to get up and running. Also available is
the Programming Kit (ELK-MK485)
which doesn't include the Magic Module™.
|
| Programming: |
| Magic Module™
programs are transferred from your PC to the Magic Module™ using the
PC’s serial port and an RS-232-to-RS-485 Data Converter module (ELK-MB485). Once programmed, the Magic Module™ can be disconnected from the
PC for stand alone applications. All programming is stored in non-volatile memory. |
Basic setup for
programming the Magic Module.
The Magic Module™ connects to
the ELK-MB485 Data Interface through the included 4-pin ribbon
cable. The ELK-MB485 connects to your computer through the
included 9-pin serial cable. Both units are powered by the
included 12V DC power pack (ELK-P1216). |
|
|
| Program
Editing: |
|
Program your Magic Modules™ using either
the ELK Application Writer or Code Editor Programming Languages . The programming software is available on the CDROM included in the
Starter Kit.
|
|
ELK
Products, Inc. Development Software:
|
The ELK Application Writer
was designed to allow non-programmers the ability to
program and utilize many of the home automation features of the
Magic Module™ simply by clicking buttons in the Application
Writer editor. This allows quick programming and customization
of a very powerful and inexpensive home automation system. (for
ELK-MM443, MM447 controllers)
The ELK Code
Editor is a Basic-like language compiled
into code bytes that the microprocessor reads and executes
through a built in operating system. This programming
environment is familiar to experienced programmers. (for
ELK-MM443, MM447, MM220 controllers)
|
|
|
KIT INCLUDES: (one each) |
• Magic Module™ (ELK-MM443).
• Data Bus Interface (ELK-MB485).
• ELK Code Editor / Application Writer Software.
• 12 Volt D.C. Plug-in Power Supply.
• 9 pin Serial Port Cable.
• RS-485 Data Bus Ribbon Cable.
• Cable to program ELK-MM220 modules.
• Instruction Manual. |
This kit is the
same as the ELK-MK485
with the addition of an ELK-MM443.
ELK-MM220
modules are programmed from the ELK-MM443.
|
|
View the
ELK-MK400 Programming Manual
(3MB) in Adobe Acrobat
format, right-click to save manual to your hard drive
Magic Module is a trademark of ELK Products, Inc. |
|
To order
the ELK-MK400
Call your nearest distributor
or ELK
at
1-800-797-9355 for more information |
|
