M1 Wireless Receiver for GE Crystal Transmitters


The ELK-M1XRFEG is a Wireless (RF) Receiver and Input Expander for use with the ELK-M1 and ELK-M1EZ8 Controls. The receiver connects to the four (4) wire data (keypad) bus of the control and integrates in much the same way as a M1XIN hardware zone expander except that a single M1XRF can handle up to 144 wireless zones (e.g. transmitter sensors or points).

The M1XRFEG receiver is a dual (2) antenna, phase diversity design capable of long range wireless coverage. It accepts both SAW and Crystal based Transmitters..

The M1XRFEG is designed to work with GE format 319.5 MHz frequency one way transmitters. Compatible GE format transmitters are also available from Resolution Products: www.resolutionproducts.com


ELK-M1XRFEG replaces the old ELK-M1XRF2G


• Adds up to 144 individual wireless zones (sensors/points)
• Operates from the 4 wire RS485 Data Bus
• Additional Receivers (up to 11) may be Connected to a single M1 or M1EZ8 Control for redundancy or greater coverage
• Flash Memory for Updating of operating Firmware


• Sensitivity: >105 dbm
• Operating Temperature: 0 to +120 degrees F
• Operating Voltage: 12 Volts D.C.
• Current Draw: 70mA
• Range: 300 to 500 ft. line of sight

NOTE: Walls or metal may reduce actual operating range.

M1 ELKM1XRF2G ELK-M1XRF2G M1xrf2g M1 wireless input expander Ge wireless input module M1 wireless expander M1 wireless receiver input receiver M1 expander input board M1 wireless GE transmitters

For more information, call ELK at (800) 797-9355.  To locate an ELK authorized distributor near you, click here.