Serial to Ethernet Converter
(used for Russound Integration)
Adobe Acrobat Reader is required to view these manuals.
If you do not have the
Acrobat Reader installed on your computer, you may download the free reader from
Adobe Systems.
A
Guide to ElkRP
This guide provides an overview of the programming features of ElkRP
Remote Programming Software.
Serial RS-232 Protocol for the M1
Protocol specifications for the RS-232 serial interface port(s) on the
ELK-M1. Using this protocol it is possible to interface with various third
party devices that can utilize serial ASCII strings. This includes:
computers, lighting systems, HVAC systems, Access Systems, and many other
types of automation devices.
M1
Audio Application Notes
This document provides an overview basic control of distributed audio
systems using the M1 Control.
Downloads Note: To download ElkRP software, M1 firmware and Release Documentation, you must go to the M1
Dealer Site and log in.
ElkRMS
Remote Management Software Version 2.0.2 Full Install (6.5 MB)
Requires product license key for full functionality. Product license key
may be purchased from you Authorized ELK Reseller. Software runs in DEMO
mode until product license key is entered into ElkRMS
ElkRM
Remote Management Software Version 1.2.12 Full Install (4.7MB)
Requires product license key for full functionality. Product license key
may be purchased from you Authorized ELK Reseller. Software runs in DEMO
mode until product license key is entered into ElkRM
ELK-IP232
Configuration Utility (2.83MB)
This utility is used to configure the network settings, serial port baud rate,
and handshaking settings of ELK-IP232. This utility is also used to update
the bootware/firmware of the ELK-IP232.
ELK-USB232
PC Drivers (456KB)
PC Drivers for ELK-USB232 Serial cable to convert USB to RS-232. This
special cable is used to connect the M1 Control to a computer that does not have
a conventional RS-232 9-pin serial port.
M1 Prox
Code Calculator (44KB)
Allows M1 Proximity access cards to be programmed through ElkRP. Based on
the site code and card number located on the card this program provides the hex
value needed to input into ElkRP. The hex value from ElkRP can also be
entered to produce the site code and card number.
Check
Sum Generator (24KB)
This is a quick and easy program that allows you to compose
an ASCII string using the RS232 protocol document. It then calculates the
checksum for you.
Code
"Calculator" for Essex 26 Bit Wiegand Output Keypads
Use this application when connecting an Essex Wiegand Output Keypad to the
proximity reader input of the M1 Keypad. The Essex keypad will produce a
26 bit Wiegand output based on two input parameters, the site code and user
pin. This "calculator" allows you to enter the site code
and user pin and gives you the hex code that can be entered in the code field of
the user's record in ElkRP, allowing remote "enrollment" of the user
pin.
