Lost transmitter on keypad

This topic has 4 replies, 2 voices, and was last updated March 6, 2026 at 4:49 pm by Jason Roberts.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
February 24, 2026 at 9:53 am #10045
Jason Roberts
On the M1 keypad – there is a “Lost Transmiiter” message.

How do run a report in Elkrp to identify which transmitter has lost signal?
February 24, 2026 at 10:58 am #10046
Brad Weeks
Connect with ElkRP2 and once connected click the LOG icon and “Receive Entire LOG”. Once the LOG is received you can Save to File
March 5, 2026 at 2:52 pm #10079
Jason Roberts
In that location – there are 2 smoke and 1 CO detector – wireless. 1 smoke ocassionally disconnects and there is a “Lost Transmitter” message on the kepad – the others do not disconnect. I remove that smoke and it automatically beeps at the keypad.

The house if about 5000 sqft and those 3 detectors are in the cabana which is a connected but separate from the main house.

Last, there is a wireless door sensor just outside the cabana, which operates fine.

Any suggestions for the 1 smoke that keeps getting “Lost Transmitter”?
March 6, 2026 at 4:36 pm #10084
Brad Weeks
Is the Smoke Detector the ELK 6052 Two-way Smoke Detector? Remove the detector from the base and make sure the RF Board is fully pressed onto the mounting PINS.
March 6, 2026 at 4:49 pm #10085
Jason Roberts
These are 5800SMOKEV – I should have given the model.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.