Keying new panel, no wireless sensors enrolling

Tagged: All wireless sensors in violation.

This topic has 3 replies, 2 voices, and was last updated June 3, 2026 at 7:51 am by John Mealey.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
June 2, 2026 at 5:14 pm #10278
John Mealey
It’s an M1 Gold, running the latest firmware with an Ethernet and 319.5 board. I swapped both boards.

Water sensors TX-E611’s (that work in another site), ITI Pet Immune, ITI Glass Breaks and Alula RE113’s, just get ‘noticed’ but are then in ‘violation’.

ALL of them. I think the board’s shot. I will spin up another board tomorrow afternoon.

Kind Regards,

John Mealey
June 2, 2026 at 6:12 pm #10279
Brad Weeks
In ElkRP2 under Send/Rvc, Enroll/Update Control and Devices what is the model number of the wireless receiver
June 3, 2026 at 7:21 am #10280
John Mealey
3 M1XRF319 1.0 2.0.4 2.o.44,

Two of the sesnors enrolled in Jade Way with out issues.

I will be swapping the board with the spare board today.

John
June 3, 2026 at 7:51 am #10281
John Mealey
The board 000062EE does not enroll anything.

The board 000037FE works normally.

Let’s cut our losses and get an RMA for000062EE.

I will be pulling the board from the 2′ x 2′ test bench and using that for the work Friday/Saturday.

Thank you for getting the ball rolling. All sensors, two different 3119.5MHz receivers, it was not the sensors.

Thanks,

John Mealey
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.