M1 Board Change - ELK Products

M1 Board Change

› M1 Support Forum › M1 Board Change

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 20, 2025 at 3:33 pm #9769
    Paul Cozzolino

      I blew up my board.  I ordered another one and successfully enrolled my bus modules.  I am getting a Fire Trouble code now.  I went into Elk Settings and did a smoke reset but that did not help any.  What else do I need to do?

      My second issue is that I can not figure out how to reconnect my Ipad to the new board.  I found a video online about the phone but this did not help.  I was able to successfully synch my phone with the new board.  However, when I did the same thing for my Ipad I had no luck.

      December 21, 2025 at 10:27 am #9770
      Paul Cozzolino

        To update my previous question I moved the jumper to the smoke position on zone 16 but I am still seeing this trouble error.  Looking at the status tab on the software the voltage on that is showing 12.1 with EOLR in the State Field.

        December 21, 2025 at 1:22 pm #9771
        Brad Weeks

          The JP1 jumper should be on 2-Wire and in RP Programming the TYPE 6 = 2-Wire Smoke

          December 21, 2025 at 1:58 pm #9772
          Paul Cozzolino

            Yes just double checked jumper is in correct position and software is configured correctly

            December 22, 2025 at 7:39 am #9773
            Paul Cozzolino

              I think I am good.  I had to change the alarm cycle that caused the system to clear the error message.  Thanks

            • Author
              Posts
            Viewing 5 posts - 1 through 5 (of 5 total)
            • You must be logged in to reply to this topic.
            Scroll to Top