The Honeywell serial number is a 7 digit number located on the wireless sensor.

Have you enrolled the M1XRF2H?

Have you created a Wireless Group in ElkRP2?

If so:

• Under Zone (Inputs) click on your Wireless Group x
• Click on the zone number you want to configure
• Set the Zone Definition, Type and any other option you need to select
• Click “Wireless Setup”
• Check “Enabled”
• Supervised will either be 0 = Not Supervised for FOBs, 1 = Normal Supervision for Window/Door, 3 = Fire Supervision for Smoke Detectors
• In the H ID box enter the 7 digit serial number for the Honeywell Wireless Sensor
• In most cases the LOOP will equal 1 or reference the Honeywell instructions for the LOOP setting
• Click SAVE and Close the “Change Wireless Zone” window
• From the Zone page click “Send to Control” or “Send and Say”