Reply To: All wireless devices not working

[Bruce Cowan]

Problem solved

I checked another computer that had ElkRP installed, with an older copy of the system configuration.  I was then able to compare the configurations.

I found the issue was all the wireless devices were DISABLED (no surprise really) for some reason.  For sure to due an inadvertent mistake by me at some point.

I re-enabled all devices and realized I must SAVE the config and then upload to the panel  (one forgets how to use the software if you only use it infrequently).

After doing this, most wireless devices were in a VIOLATED state. I found I had to cycle them (open/close or motion detect) before they returned to NORMAL status.

What threw me off, when initially looking into the issue, was although the devices were DISABLED at the time, their status indicated “NORMAL” in the system status display.

I would have thought the options would be Normal, Violated, or Disabled

Anyway, another instance of operator error  🙂