Are you able to connect to the system using the ElkRP2 software? If so you can learn in a wireless device from ElkRp2 if you have the Honeywell serial number. From keypad programming:
- Press the ELK key, screen should display 1-View/Control Automation Fncts
- Press the 9 key, screen should display 9-Installation Programming (0)
- Press the right arrow key and you should be prompted “Auth Required Enter Valid PIN — This is the Installer Level Keypad Programming Code
- Screen should display 01-Bus Module Enrollment
- Type 14, screen should display 14-Wireless Setup
- Press the right arrow key, screen should display 1: Rec Sel {Up/Down symbols} Prg {right arrow symbol} Receiver Options
- Type 3 and screen should display 3: Learn Sel {Up/Down symbols} Prg {right arrow symbol} Wireless Transmtr
- Press the Right Arrow key
- Type in the 3 digit zone number for the zone you want to learn in and press the right arrow key
- Screen will display WZone = xxx (xxx= the zone number to learn in) TransmitrToLrn
- Press the right arrow key
- Insert the battery into the sensor or trip the tamper switch or move the magnet away from the sensor
- When Learned In you should hear a chime from the keypad and the keypad screen will advance to the next available wireless zone
- Press the ELK Key to save
Additional information can be found starting on page 47 of the M1 Installation Manual and within the M1XRF2Hv2 Installation Manual