› M1 Support Forum › Override stay mode when using a particular keypad? › Reply To: Override stay mode when using a particular keypad?
Thanks Brad. I had somewhat come to the same conclusion but was hoping for something better.
If I uncheck that option, is there a way I can recreate the behaviour using a rule? I looked but couldn’t find any obvious way of detecting Zone change by type of Zone (ie entry/exit zone) to see if there was a violation during the Arm process. Additionally, with multiple exit zones, I don’t even have the option of using a logical “OR” so not sure how I would handle this?
The goal, of course, would be to recreate the behaviour of the option via a Rule so I can add additional logic to it.
Any suggestions would be greatly appreciated.