Verify the DIP Switches for the M1XIN are set correctly — for address #4 DIP Switch 3 UP and the rest down. Once set power cycle the M1XIN. Under the Send/Rcv Icon, Enroll/Update Control and devices make sure the M1XIN’s are enrolled at their correct addresses. Under Zone (Inputs) highlight any unwanted Groups, right-click and Remove the Group and Send to Control. Under Areas highlight any unwanted Areas, right-click and Remove Area, Send to Control — save your account. After disconnecting and reconnecting if you still receive the Conflict with Zone Inputs and/or Areas you may need to default the system through keypad programming —- Menu 9 Installation Programming, 07- Globals System Definitions, G45- Default Control, right arrow and type 99 — Entire System. Once complete reconnect and Send All to the system.