- This topic has 2 replies, 2 voices, and was last updated December 7, 2020 at 3:51 pm by M1 Installer.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Hi, Is it possible to blink UPB lights when triggered by an Elk rule? I can only see the options to turn lights on and off or to a specific lighting level. I’m looking to blink the lights when an alarm condition is triggered for a set period. It seems that blinking the lights is possible directly in UPStart, but not through the Elk? Thanks!
ELK Tech Support
Please take a look at the bottom of page 13 of the M1XSP Installation Manual for more information on Link (Scene 64)”Alarm Flash”. When this Link is activated from the M1, the M1 will automatically send a special “Flash” command. All devices which are programmed to respond to Link 64 will immediately begin flashing until the link is deactivated (turned off) from the M1.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.