› M1 Support Forum › Get zone attributes from API

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 28, 2021 at 11:30 pm #5087
    JimBo

      Is there any way to get Zone Attributes like Bypassable or Force armable from the API, I’ve searched through the entire ASCII Protocol & Interface Specification and can not see anything.  I’d also like to know if a keypad has a temperature sensor?

       

      March 30, 2021 at 3:56 pm #5092
      Brad Weeks

        To know if a keypad has a temperature sensor he could send the lw command.  If it’s non-zero then assume it has a sensor. Page 30, section 4.23.1.    Zone attributes like bypassable and force armable are not available from the API.

        March 30, 2021 at 6:12 pm #5096
        JimBo

          Thanks, I was hoping to not make an assumption based on the temperature coming back as zero.  Bummer that zone attributes are not available in the API, that would make user interfaces using them much smarter…

           

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.
        Scroll to Top