M1 Support Forum M1ZTSR zone showing “Not Ready”

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #5171
    Charles Winterble

      I’ve had a ELK-M1ZTSR hooked to a M1 main panel for months, working fine.  Zone 1 , zone definition 33, fast response 40 ms.  Now I am getting an occasional message “zone 1 not ready”.  Nothing was changed.  Any ideas?

      Thanks for the help.

      #5180
      Brad Weeks

        The Keypad is displaying Zone 1 is not Ready or in ElkRP2 under Status? When the keypad displays Not Ready x Zn this indicates the total number of Zones which are not secure. Press the Up Arrow key to view each zone which is not secure. Check to make sure in programming for the M1ZTS that you do not enable “Bypassable” and Zone 1 isn’t Bypassed

        #5181
        Charles Winterble

          I believe that is it.  I was interpreting zone 1 not ready.  It was actually 1 zone not ready.

          Thanks for the help.

        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.
        Scroll to Top