M1 Support Forum Rule to delay arming a zone

Tagged: 

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #5817
    MKG

      When the system is armed, I would like to delay arming/securing a zone.
      Basically, I would like to do this:

      Whenever system is armed
            Wait for 120 seconds
            Secure Zone 10

      What setup/rules can I use to achieve this? Is there any special configuration/attributes needed for the zone?

      Thanks!
      MKG

       

      #5818
      MKG

        Just to clarify, “Zone 10” is not an entry/exit zone. Therefore, I cannot use entry/exit delay.

        #5819
        Brad Weeks

          Try the following:

           

          Whenever My Home (Area 1) is Armed Any Mode

          Then Bypass Zone 10

          Then Turn OUTPUT 100 ON for 2 Minutes: restart Timer if running

           

          Whenever OUTPUT 100 TURNS OFF

          And My Home (Area 1) is Armed Any Mode

          Then Unbypass Zone 10

        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.
        Scroll to Top