- This topic has 0 replies, 1 voice, and was last updated July 24, 2023 at 3:35 pm by Mike Desmarais.
Viewing 1 post (of 1 total)
-
Posts
-
Is there anyway possible to use the low level audio signal (RCA analog output from CD player or audio streamer) as an input to the Elk M1 Gold (or associated) board?
I would like to use an low level audio signal from and audio pre-amp to trigger a heavy duty relay to pass line voltage (120vAC) to turn on a separate amplifier.
Thanks-
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.