M1 Support Forum Changing user Code

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #5580
    Andrew Hancock

      I have had my system for 12  years and I need to change the user code. In looking at the user guide it says I need a “master level user code” to do that. I have no idea if the user code I have been using is the “master” or not. What do I do if I don’t have the “master”?

      Brad Weeks
        • From the keypad press the ELK Key
        • Screen should display 1-View/Control Automation Fncts
        • Press the 6 Key
        • Screen should display 6-Change User Codes
        • Press the Right Arrow key at which point you should be prompted “Auth Required Enter Valid PIN” —- Try your regular Arm/Disarm Code
        • If successful screen should display 001: Sel Change
        • Scroll Up/Down to the User you need to change and press the Right Arrow Key
        • Enter the new 4 Digit Code
        • Press the ELK Key to save the change
        • Press the “*” to exit programming


      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.
      Scroll to Top