M1ZTSR connection - ELK Products

This topic has 3 replies, 2 voices, and was last updated December 7, 2020 at 5:32 pm by ELK Tech Support.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
December 4, 2020 at 5:35 pm #4414
M1 Installer
Can I connect a M1ZTSR to a zone on a M1XIN, or does it have to run back to the main board?
December 7, 2020 at 5:31 pm #4528
ELK Tech Support
The M1ZTS(R) must connect to a zone on the M1 Main Board. It is possible to have a total of 16 M1ZTS(R) connected to the M1 Zones 1-16.
December 7, 2020 at 5:32 pm #4529
M1 Installer
Can the temperature be displayed via M12Go? Currently, the status shows that it is connected, but displays no temperature. The temp does display on the keypad and via another web based app, however M12Go does not display. Thank you.
December 7, 2020 at 5:32 pm #4530
ELK Tech Support
Under Climate, Sensors, you should see the temperature reading from the M1ZTS Temp Sensor. If not click Main Menu and “Re-Sync”.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.