ZWAVE Lock problem

M1 Support Forum ZWAVE Lock problem

Tagged: 

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #6260
    Carlos Santillana

    Hi, I have a situation with my ZWAVE lock, it was working perfectly but not it stop working. When I use the Levinton RF+ Installer tool it works. I can unlock and lock. The Node for this device is 10 and the Controller its # 3

     

    When I go to the ERP Tool, I cant make it work. In the Automation – lighting I have in port 10 as Serial Expander and type Other.

    And in the rules, U cant go more than 7 in the port.

     

    What can I do?

     

    Thanks for all your help.

     

    #6261
    Carlos Santillana

    Please if you can help, let me know.

    #6264
    Brad Weeks

    From the ELK keypad Menu 1-View/Control Automation Fncts, 2-Lighting you’re able to control the ZWave Lock? From the Leviton Software Re-Associate the Leviton VRCOP and then Power Cycle the ELK M1XSLZW. After the M1XLZW Status LED returns to a normal blink pattern try your rules again.

    #6266
    Carlos Santillana

    I cant able to control from the keypad. I did re-associate the levinton VRCOP and power off the M1XSLZW ( had to turn off all the M1) and disconnected VRCOP.

    These are my settings in the Levinton VIZIA

    CONTROLLER (3)

    LOCK (10)

    This works fine.

    in the M1 RP

    Automation: lighting:

    DEVICE 3 – FORMAT: standard – Type: OTHER

    DEVICE 10 – FORMAT: SERIAL EXPANDER – TYPE: OTHER

    the lights works fine.

    Please let me know if I need to do anything.

    If not can you contact to have this fixed via phone call?

     

    #6267
    Brad Weeks

    The ZWave Locks are not a Light device but instead you have to create the special Text Strings —- refer to page 12 of the M1XSLZW Installation Manual for additional details

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.
Scroll to Top