M1 Wireless Receiver for Honeywell Transmitters

ELK-M1XRF2H

The ELK-M1XRF2H is a Wireless (RF) Receiver and Input Expander for use with the ELK-M1 and ELK-M1EZ8 Controls. This receiver is compatible with Honeywell (Ademco) 5800 series wireless transmitters. The M1XRF2H connects to the four (4) wire data (keypad) bus of the control and integrates in much the same way as a M1XIN hardware zone expander except that a single M1XRF2H can handle up to 144 wireless zones (e.g. transmitter sensors or points).

Multiple M1XRF2H receivers can be installed on the data bus allowing hundreds if not thousands of square feet to be covered by strategically placing each receiver in a different location.

The M1XRF2H is designed to work with Honeywell (Ademco) format 345 MHz frequency one way transmitters. Compatible Honeywell format transmitters are also available from Resolution Products: www.resolutionproducts.com


Information:


Features:

• Adds up to 144 individual wireless zones (sensors/points)
• Operates from the 4 wire M1 RS485 Data Bus
• Additional Receivers (up to 11) may be connected to a single M1 or M1EZ8 Control for redundancy or greater coverage
• Flash Memory for Updating of operating Firmware



Specifications:

• Sensitivity: >105 dbm
• Operating Temperature: 0 to 120 degrees F
• Operating Voltage: 12 Volts D.C.
• Current Draw: 70mA
• Indoor Range: 300 to 500 ft. line of sight

M1 ELKM1XRF2H ELK-M1RF2H M1xrf2h M1 wireless input expander Ademco wireless Honeywell wireless input module M1 wireless expander M1 wireless receiver input receiver M1 expander input board M1 wireless 5800 transmitter

For more information, call ELK at (800) 797-9355.  To locate an ELK authorized distributor near you, click here.